Le Zelgear Igla 410 est un kayak gonflable, il se compose de deux parties – des tubes latéraux gonflables avec un fond de tension et un fond gonflable de point de goutte séparé.
Les tubes latéraux sont profilés et présentent une cloison longitudinale interne. Ce modèle est l’un des plus étroits de la classe des kayaks gonflables. Cependant, il a suffisamment d’espace interne pour un positionnement confortable et a une bonne stabilité en raison de l’angle correct de bas en côté.
L’IGLA 410 est un kayak solo spacieux. Il y a beaucoup de place dans un kayak pour un, et même avec une marge. Les contours extérieurs ont un bel aspect et d’excellentes caractéristiques hydrodynamiques.
Le kayak dispose de toutes les fixations pour le montage du gouvernail (fixations au volant sur la poupe et base en PVC avec sangles sur le fond).
Lorsque vous réglez le gouvernail, vous pouvez arrêter de prêter attention aux vagues ou au vent qui essaie de vous faire dévier. Le contrôle du kayak avec les pédales est intuitif. Et les supports de genou réglables fournissent un contrôle inégalé du bateau et donne la puissance du kayak tout en pagayant
Il faut environ 6-8 minutes pour assembler le kayak. Il suffit de tourner le kayak pour → mettre le fond à l’intérieur et le fixer avec des boucles fastex sur les côtés pour → vérifier les soupapes de pression (doivent toujours être en position ouverte) → pour gonfler les côtés pour → pomper le fond pour → placer les sièges dans la position souhaitée, en les fixant avec des mousquetons aux fixations sur les côtés et le fond
.
Une caractéristique pratique est que ce modèle est également bon pour les excursions de jour pour 2 pagayeurs. Vous pouvez acheter un deuxième siège.
Les fixations suivantes sont préinstallées sur le kayak Igla 410 :
• boucles sur les côtés et le fond pour placer le siège en position solo
• fixations pour les supports de genou (en position solo)
• boucles sur les côtés et le fond pour l’installation de deux sièges
• pour installer un pont de pulvérisation de protection – Velcro fermé à l’avant et à l’arrière et triangles en PVC sur les côtés
• fixations sur l’arrière du kayak pour installer le kit de gouvernail
• base en PVC avec sangles pour monter les pédales pour le pagayage solo
Capacité de charge : 150 litres de bagage avec un pagayeur ou 80 litres avec deux pagayeurs.
Caractéristiques du kayak :
• Conception unique avec cadre gonflable – rigide, hydrodynamique correspond aux modèles en plastique
• double protection de fond fiable •
polyvalence d’utilisation – pratique pour ramer seul ou par paires
• compartiments de chargement spacieux à l’avant et à l’arrière du kayak • harnais fait d’un extenseur durable pour fixer la
charge sur l’arrière •
sac à dos pratique avec fixation des pièces de kayak à l’intérieur et à l’extérieur à l’aide de sangles de serrage
L’équipement standard comprend un siège gonflable, 1 ensemble de supports de genoux, une pompe à main, un kit de réparation et un ensemble de sac à dos.
Vous pouvez acheter un sprayeck en plus, avec un ou deux cockpits, un siège pour un deuxième pagayeur, un kit de gouvernail.
The Zelgear Igla 410 is an inflatable kayak, it consists of two parts – inflatable side tubes with a tension bottom and a separate dropstitch inflatable bottom.
The side tubes are profiled and have an internal longitudinal partition. This model is one of the narrowest in the class of inflatable kayaks.
However, it has enough internal space for comfortable positioning and has good stability due to the correct bottom-to-side angle.
The IGLA 410 is a spacious solo kayak. There are a lot of place in a kayak for one, and even with a margin. The outer contours have a beautiful appearance and excellent hydrodynamic characteristics.
The kayak has all the fasteners for mounting the rudder (steering wheel fasteners on the stern and PVC base with straps on the bottom).
When setting the rudder, you can stop paying attention to waves or the wind that tries to knock you off course. Controlling the kayak with the pedals is intuitive. And the adjustable knee supports provide unsurpassed boat control and gives the kayak power while paddling
It takes around 6-8 minutes to assemble the kayak. You just need to turn the kayak around → put the bottom inside and fasten it with fastex buckles to the sides → check the pressure valves (should be always in the Open position) → inflate the sides → pump up the bottom → set the seats in the desired position, fastening them with carabiners to the fasteners on the sides and bottom
A convenient feature is that this model is also good for daytime trips for 2 paddlers. You can purchase a second seat.
The following fasteners are pre-installed on the Igla 410 kayak:
• loops on the sides and bottom for setting the seat in the solo position
• fasteners for knee supports (in solo position)
• loops on the sides and bottom for the installation of two seats
• for installing a protective spray deck – closed Velcro on the bow and stern and PVC triangles on the sides
• fasteners on the stern of the kayak for installing the rudder kit
• PVC base with straps for mounting pedals for solo paddling
Load capacity: 150 liters of luggage with one paddler or 80 liters with two paddlers.
Features of the kayak:
• unique design with inflatable frame – rigid, hydrodynamics corresponds to plastic models
• reliable double bottom protection
• versatility of use – convenient for rowing alone or in pairs
• spacious cargo compartments in the bow and stern of the kayak
• harness made of durable expander for fixing the load on the stern
• convenient packing-backpack with fixation of the kayak parts inside and outside with the help of tightening straps
Standard equipment includes one inflatable seat, 1 set of knee supports, hand pump, repair kit and backpack package.
You can purchase a spraydeck additionally, with one or two cockpits, a seat for a second paddler, a rudder kit.















































Avis
Il n’y a pas encore d’avis.